Connect Systems CS1001 Manual de Instalação descarregar pdf (Página 43)

APPENDIX 3

CS1001 Plug-on Dualcom

The pins are mounted on the host unit, e.g. the control panel. The pins are

fitted on a plastic spacer, 0.156 inches (3.96mm) pin centre to centre. There

are two rows of 8 pins spaced apart by 4.25 inches (108mm) pin centre to

centre.

The view below is looking at the pins mounted on a host unit, onto which the

Dualcom plugs. Note that some equipments label the pins 9-16 as ‘1-8’.

Pin Allocation

1 Input to Communicator Input 1 Fire

2 Input to Communicator Input 2 P.A.

3 Input to Communicator Input 3 Burglar

4 Input to Communicator Input 4 Open/Close

5 Input to Communicator Input 5 (mains fail etc)

6 Output from Communicator Tell Back (comms successful)

7 Output from Communicator Communications Fail

8 Input to Communicator Low Battery

9 Input to Communicator +12 volts

10 Input to Communicator 0v

11 no connection

12 Input to Communicator +5v

13 Input to Communicator Input 6 Bell active

14 Input to Communicator Input 7 Alarm

15 Output from Communicator PSTN Line Fail

16 Output from Communicator Reset host unit (not used)

1o o 9

2o o10

3o o11

4o o12

5o o13

6o o14

7o o15

8o o16

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 49 50

Sem comentários

Connect Systems CS1001 Manual de Instalação Página 43