Connect Systems CS4000 Manual do Utilizador descarregar pdf (Página 4)

Eclipse 4000 Maintenance Manual

01/12/02 V2.00 Page 4

INSTALLATION:

1. Once located into the correct position, the system must be locked down to prevent movement and

contact with adjacent line machinery. It should also be level in operation.

2. Always use an RCD feed for the system (16 Amp rating).

3. Ensure that terminal covers are replaced after connection of the mains power cable.

4. Release the Checkweigher motor cables and connect to the motors and secure. Ensure the sealing

rubber is located in place prior to securing.

5. Connect a suitable air supply (4 to 6 BAR) to the system. MAXIMUM MUST NOT EXCEED 10

BAR.

6. Check that none of the conveyors are obstructed or in contact with adjacent equipment.

7. The customers should fit guarding at the interface of the CINTEX system with their own system.

There is a potential hazard at the conveyor junctions plus the reject device on the outfeed

conveyor.

8. If the system is used as a stand alone system, then extra guarding around the outfeed end and reject

device should be fitted.

NOTE: When the conveyors are stopped the reject devise is disabled.

It is advisable to isolate the system before undertaking any maintenance or cleaning

work.

Combined System:

Isolator Switch E-Stop

CS4000 electronics Cabinet Start Button

Mains In

Metal Detector Head CW Reject Hood

MD Reject Bin

1 2 3 4 5 6 7 8 9 ... 12 13

Sem comentários

Connect Systems CS4000 Manual do Utilizador Página 4