Eclipse 4000 Maintenance Manual
01/12/02 V2.00 Page 6
HAZARD WARNINGS:
Only suitably trained personnel should undertake cleaning and maintenance.
1. The systems are designed for incorporation into a line; (certificate of incorporation) therefore the
customer must take account of the potential pinch hazards that will exist at the interfaces with
the rest of the line. CINTEX has guarded up to the ends of their system.
At the outfeed end, where the reject device is located, It is not possible for CINTEX to fully guard
to EN294. The customer therefore should take steps to protect their side of this and the infeed
interface.
2. There is a risk of injury due to reaching in and trapping arms, hands or fingers in an activated
pusher, diverter paddle, or powered dipping or lifting conveyor reject, if the customer does not
guard their take off conveyor, at this interface.
3. If the conveyor motors are stalled, the temperature may rise above the normal operating
temperature of 70
0
C, and may cause a burn if contact made with bare skin.
4. Burns may occur due to friction between conveyor belts if jammed.
5. Injury may occur if air blast outlets are touched during operation. Air pressure to the system
MUST NOT exceed 10 BAR. Normal operating pressure should be between 4 and 6 BAR.
6. BEWARE of items ejected from the reject station during operation, when either emptying a reject
bin or working on or around that area. Reject packs can be ejected from the line at high speeds
especially by an air blast system. Also beware of constituent parts of packs being blown off a line
by an air blast device. Always locate a receptacle under the REJECT HOOD (where fitted in place
of a bin) prior to operation of the system. If the system is to be used as a stand alone unit then
beware of product falling off the end of the outfeed conveyor.
7. Always STOP the conveyor system before undertaking cleaning of any part of, or underneath the
transport system. There is a DANGER of trapping and injury to fingers in drives and rotating parts.
8. DO NOT HOSE DOWN the system unless Cintex has given EXPRESS permission in writing.
9. DO NOT ENTER THE TOP HATCH, above the weigh conveyor, while the conveyors are
running. Injury may result from contact with the activated reject device.
10. Always or isolate the system before undertaking any system maintenance.
11. When cleaning down debris and cleaning fluids will fall through to the floor and will need to be
cleaned up to prevent a hazard from slipping or tripping.
NOISE LEVELS:
The Eclipse free standing Checkweighers and the Eclipse Checkweigher metal detector combinations
systems, produce less than 70 dB(A) of noise measured at the operator station
Pneumatic rejects actuators (other than air-blast) produce peak noise levels of less than 85 dB(C) ,
measured at the operator station..
Air-blast rejects produce peak noise levels of greater than 85dB(C) but les than 130dB(C), measured
at the operator station.
All noise measurements were made using a “01DB SVANTEK SVAN912A” noise meter from the
operator station.
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentários a estes Manuais